Материал из WikiPolitex
Septic water tanks are a method of treating water from properties that aren't connected to main drainage. You will find different types of septic system systems, which contain an underground septic system coming in different shapes and sizes. It connects to a secondary soil treatment system, which most of the time is a land drainage system by means of a drain-field. Ground septic tanks work with sewerage systems where raw sewage and wastewater discharge it to the tank. Here solids are separated in the liquid waste. Fats and oils float to the peak of those plastic vertical tanks and form a crust layer with human waste and food scraps sinking to the bottom.
The waste at the end of the tank forms a sludge layer, which then encounters bacteria, which are the natural colonizers of plastic septic tanks which will digest more than sixty percent of the sludge. The dirty septic water flows out of the tank towards the drain-field with �T� pipes in the plastic vertical storage tanks holding back the floating layer preventing it from accessing the outlet of the tank. Septic water tanks ought to be emptied annually to avoid sludge and crust layers from going too deep. This can help by preventing higher concentrations of suspended solids washing in the drain-field.
The �T� pipe is part of the opening pipe from the second chamber of the tank, that is usually square. Vent pipes of ground septic tanks are usually installed in the first chamber along with the second one for the purpose of venting gases for example hydrogen sulphide and methane, which the sludge produces. Our recommendation is that strong covers go completely over plastic septic tanks to prevent animals or perhaps children from falling into the tank. When these covers collapse, it may be with fatal results hence the requirement for strong covers.
Modern septic water tanks are made of polyethylene and GRP each of which are usually obtainable in spherical shape using the top having a spherical shape that has a narrow shaft. They don't produce effluent similar in quality as two chamber tanks and are usually not placed in front of numerous conversion units. You should be careful to ensure that during the emptying of the ground septic tanks in high water table sites problems don't occur due to the tank rising from the ground. In this case our recommendation is that you install the tank with a concrete surround.
You need to get a site inside your residence or neighborhood that'll be suitable for plastic septic tanks systems. A website with soil that contains too much clay or that is too porous or which has the bedrock too close to the surface isn't suitable. Clay soil soaks the septic effluent away while soil, that is too coarse won't support the effluent for long periods in order that it may be treatable. In such cases, you can use a non-sewerage treatment plant although it may also be possible to adapt septic water tanks systems to match even unsuitable sites if meticulous planning and design is done by an expert.